I have my EER diagram all laid out, but one of the relationship lines insists on being drawn on the RHS of the 2 tables which are aligned vertically, meaning it crosses 2 other lines. It would be clearer if this line was drawn down the LHS of the 2 tables where it would cross no other lines.
If I move the tables around, the line may switch sides, but once they're back in vertical alignment, it insists on being drawn on the crowded RHS side. I simply cannot get it to stay on the clearer LHS.
I thought I should be able to to drag the line into a preferred position, but sadly this seems not to be possible. So...
Is there any way to move or in some way influence where relationship lines are drawn?
If I move the tables around, the line may switch sides, but once they're back in vertical alignment, it insists on being drawn on the crowded RHS side. I simply cannot get it to stay on the clearer LHS.
I thought I should be able to to drag the line into a preferred position, but sadly this seems not to be possible. So...
Is there any way to move or in some way influence where relationship lines are drawn?