Hello again,
I installed the latest Workbench this morning and things ran smooth for a while. Than the software crashed and now all I get from it is a pop-up that reads
Application has generated an exception that could not be handled.
Process ID=0x150(336), thread ID=0x230 (560).
Click ok to terminate the app
Click Cancel to debug.
Any suggestions on a fix?
Thank you very much.
I installed the latest Workbench this morning and things ran smooth for a while. Than the software crashed and now all I get from it is a pop-up that reads
Application has generated an exception that could not be handled.
Process ID=0x150(336), thread ID=0x230 (560).
Click ok to terminate the app
Click Cancel to debug.
Any suggestions on a fix?
Thank you very much.